New member help needed.

D

Dirtbox

New member
Hello.
I have a ultradive and the crown controlling the internal bezel doesn't seem to lock....I'm not even 100% whether it should lock but the internal bezel seems to move without turning the crown...I'm sure that can't be correct.
I'm based in the uk...any help or advice would be much appreciated.
Many thanks.
Pail.
 
J

jbcollier

Member
Enicaristi
Sherpa
It has a gear and a toothed bezel:

s-l1600.jpg


s-l1600.jpg



s-l1600.jpg



What goes wrong? The gear shaft can break, teeth break off the bezel, etc. The bezel itself does not lock. Tension against the bezel by the crystal holds it in place. Please be careful and make sure you bring it to a watchmaker experienced with Enicar super compressor watches. It can be very difficult to remove the back. Lots and lots of people and watchmakers try with the three pin removal tools. These can easily slip and gouge the back. Have a look at some watches for sale online and you will see many/most are deeply gouged. Fair warning!
 
D

Dirtbox

New member
jbcollier said:
It has a gear and a toothed bezel:

s-l1600.jpg


s-l1600.jpg



s-l1600.jpg



What goes wrong? The gear shaft can break, teeth break off the bezel, etc. The bezel itself does not lock. Tension against the bezel by the crystal holds it in place. Please be careful and make sure you bring it to a watchmaker experienced with Enicar super compressor watches. It can be very difficult to remove the back. Lots and lots of people and watchmakers try with the three pin removal tools. These can easily slip and gouge the back. Have a look at some watches for sale online and you will see many/most are deeply gouged. Fair warning!
Click to expand...
Thank you so much for the information. Much appreciated. Can you recommend a watchmaker to help with this? I'm based in the uk...thanks again. Paul.
 
You must log in or register to reply here.
Top