SOLD. $25. 3D printed case back opener for a Enicar Super-Divette/ sherpa guide or similar seapearl compressor model

[mc1]

I picked this up from a WUS member recently. There was a bit of confusion around what model I was after and I ended up with the wrong caseback opener. It owes me 30 usd. Would do a swap for a sherpa graph opener also. Will ship world wide.

 

[carl]

I picked this up from a WUS member recently. There was a bit of confusion around what model I was after and I ended up with the wrong caseback opener. It owes me 30 usd. Would do a swap for a sherpa graph opener also. Will ship world wide.

Will this open an ocean pearl? Looks like it would...

 

[mc1]

Will this open an ocean pearl? Looks like it would...

Hi Carl. It should do. The measurement is approx 31.7 from outer edge to outer edge of the flower pattern

 

[Trancewidth]

Do you still have this? PM me

 

[mc1]

.

 

[Blue57stealth]

Are you producing any more of the caseback openers please. Thanks. Carl

 

[mc1]

Hi Carl. I picked this up on watchuseek. I'm pretty sure I sighted one on ebay although the seller wanted over 50 usd or you could have one 3D printed