Finally, installed in the watch and now I can wind it again and working perfectly...
So, the stem is a little long, I need to trim it down.
But the watch is winding and working well.......
Thanks to all of you helping me find the correct part....
Here's my update. Bought a crown/stem combination on Ebay..$20 ....came from The Netherlands.
Here's how it came (see pic)
The 3rd pci is the old stem and the new stem-crown combination
About the crown - I believe it is a domed crown, dust-proof type...for mine - gold in color. non-gold color below from similar watch.
As for the stem - I have found that it may be W2153 or a Valjoux 92 #401 stem
OK Steve...I got hold of a very, very tiny (0.5 mm) flat head screwdriver ....and I pulled them stem.
It took 2-1/3 turns of the set/holding screw to release it.
Here are the pictures....The last and only watch maker I took it to seemed to have grinded the end up quite a bit, maybe to fit the...
Yes,
I can do that. I've tried to remove the winding stem, but the screw holding it in place is ~ 0.8 mm. I only have a 1 mm flat head at this time. I have tried to rotate the holding screw 2 + 1/3 turns, but still nothing on getting the winding stem out. Enicar customer support had no thing...
Thank you so much...i’ll Look into those...
Mine should have a 92 Valjoux....
I’ve been to three Urhmachers - NYC, Houston and Frankfurt...and they weren’t able to find replacements....i’ll Keep searching....so so can use it again....
Hi all,
I'm glad I found this forum. I'm pleased to find other Enicar enthusiasts.
Need some help ....maybe someone can steer me in the direction of sourcing a crown and probably a crown/stem combination for my 1005 CH P.
It's a wind-up watch, so not very useful without a crown....
I'll add...